LaSeal 977 Clear MS Crystal Clear MS Polymer Sealant

Technology data:The following data are only for reference purpose, not intended for use in preparing specification

LaSeal 977 Clear MS Crystal Clear MS Polymer Sealant

Standard:
Meets or exceeds the requirements of the following specifications:
The requirements of VOC content specifications in LEED credit EQc4.1
“Low-emitting products” of SCAQMD rule 1168.
The French VOC requirements for class A+
CE marked for EN 15651 for façade applications.

1.It must not be used in totally confined spaces where sealant cannot cure due to lack of atmospheric moisture.
2.Cannot be used on natural stone. Because the adhesion surface will discolor under influence of the sealant (looks wet) and also this is visible through the sealant due to its clear look.
3.Do not use in applications where continuous water immersion is possible.
4.Prolonged exposure to direct sunlight can cause discoloring, Joint Width 5mm 10mm Joint Depth 5mm 5mm Efficiency /310 ml 12 meters 6 meters

● Following cleaning procedure and materials are recommended:
● Glass Degrease with alcohol or MEK
● Aluminium, light alloys and stainless steel Degrease with alcohol or MEK
● Other Metals Lightly abrade then degrease as above
● Wood Lightly abrade surface then remove dust
● Plastics Degrease using an agent recommended by plastics manufacturer
● Concrete and other alkaline Surfaces Brush and remove dust

1. Before the application, the tip of the cartridges is cut and a plastic cap is fixed.
2.The tip of the cap is cut according to the width of the surface and fixed to the cartridge gun.
3.The sausage package is cut from one edge and fixed to a suitable gun. Then the cap nut is screwed to the cylinder of the gun.
4.The joints should be filled at one time and without gaps during the application.
5.The surface of LaSeal Universal applied in the joints should be smooth ended with a dampened spatula, glazing tool, joint iron or by hand immediately.
6. If used, the adhesive tape should be removed afterwards.
7.The opened packages should be consumed as quickly as possible.
8.The contaminated areas and used tools should be cleaned with white spirit or alcohol. It is cleaned only mechanically after cured.
9.Joint width/depth ratio should be 2:1.

1.They should be protected from water, frost and adverse air conditions.
2.They should be kept dry and cool on wooden pallets at between +5 degree C and +25 degree C in moisture free conditions.
3.The opened products should be consumed immediately.
4.Shelf life is maximum 12 months conditional to complying with the aforementioned storage conditions.